精密行星減速機安裝伺服馬達指南

Follow the steps below for installing of precised planetary gearbox with Servo motor

行星減速機安裝伺服馬達前務必閱讀此安裝指南

 

Step 1

Checking the conformity of mounting side dimension on planetary gearbox with servo motors' output flange and shafts.

核對伺服馬達型號與減速機規格是否正確

 

Step 2

Remove the black stopper on mounting hole, then Lossen both the hexagonal bolt on input hollow shaft(bore) by hexagonal wrench.

取出扣式塞頭；使用六角扳手將2組束緊環螺絲鬆開

 

Step 3

Remove the key from keyway on the servo (stepper) motor 

將伺服馬達軸上的鍵拿掉

 

Step 4

Clean and remove any dust or particales on the mounting surfaces of planetary gear box and servo motor

請將減速機與伺服馬達；配合面擦拭乾淨

 

Step 5

Check the dimension of  the output shaft of servo motor before installing; if sleeve is needed, please pre installed it into the input hollow shaft(bore) of the planetary gearbox.

檢查伺服馬達輸出軸(出力軸)尺寸；如需要軸套請裝入減速機輸入軸內

 

Step 6

Install the servo motor vertically into the mouting side of planetary gearbox.

將伺服馬達垂直裝入減速機

 

Step 7

Tighten the screw by adjustable wrench between planetary gearbox and servo motor.

鎖緊伺服馬達與行星減速機固定之外六角螺絲

 

Step 8

Tighten both the hexagonal screw of input hollow shaft(bore) on planetary gearbox by hexagonal wrench.

使用六角扳手將束緊環螺絲稍做固定

 

Step 9

Use a torque wrench to check the if the hexagonal screw is tighten

使用扭力扳手將束緊環螺絲鎖緊

 

Step 10

Replace the black stopper back to the mounting side of planetary gearbox.

裝回位於安裝法蘭的扣式塞頭

 

For more information on planetary gearboxes products, visit our products page or contact Varitron.

如需詳細精密行星式減速機，遊星式減速機請參考產品專區。